Übersetzung für 'V-belt' von Englisch nach Deutsch

V-belt

Keilriemen {m}tech.

---

cogged V-belt

Zahnkeilriemen {m}engin.

Werbung

narrow V-belt

Schmalkeilriemen {m}tech.

V-belt drive

Keilriemenantrieb {m}electr.tech.

V-belt pulley

Keilriemenscheibe {f}tech.

V-belt pulleys

Keilriemenscheiben {pl}

V-belt tensioner

Keilriemenspanner {m}

V-rib belt

Keilrippenriemen {m}

V-ribbed belt

Keilrippenriemen {m}tech.

• Engine power was transferred to the rear wheel through a centrifugal clutch equipped with a continuously variable V-belt drive.
• It used a friction transmission and a copper-riveted V belt final drive.
• Camshaft drive by two-stage chain drive, Dynamo driven by V-belt - Camshaft driven by vertical Dynamo.
• Charles' uncle John Gates invented the V-belt in 1917, a staple component in all modern automotive and industrial applications.
• 8 L displacement of the Hanomag L 28 was equipped in 1953 with a Roots turbocharger, which was driven by a V-belt.

• The two-stroke motorcycle engine, under the flatbed, was coupled over a V-belt on the left rear wheel and was pushed to start, and choked to stop, which was not difficult from the driver seat in the rear of a 250 kg payload vehicle on a flat road.
• There were at least two variants for engine cooling: a simple solution with a V-belt-driven, four-bladed fan in front of the cylinder, which was only seen on the test vehicles, and a more elaborate design with impeller on the front crankshaft stub and air baffles for cooling air, which was also described in the manuals and spare parts lists.
• The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys.
• The dynamo had been switched to the left hand side and was now driven by an additional v-belt from the fan pulley.
• The motor was a rear-mounted twin cylinder air-cooled 50cc engine from Motobécane which powered the rear wheel via a V-belt and chain linkage.

• The push rod engines ranged in size from 15 cubic inches in 1904 to 29 cubic inches by 1911, had a suction intake valve and were driven by a V-belt.
• The Staib Helicopter is a powered by a Continental C85 with a V-belt linkage.
• Meanwhile the bobbin winder has a separate belt: the models 27 and 28 drive the bobbin winder using a long round or V belt to the motor, whereas the 'modernized' models 127 and 128 drive the bobbin winder directly off the handwheel by means of a small "ring belt" or "bobbin belt" acting as a tire.
• Drive mechanisms can be a single v-belt, a serpentine belt or multiple v-belts.
• The material of a V-belt or multi-V serpentine belt tends to wedge into the mating groove in a pulley as the load increases, improving torque transmission.

• In addition, 'T' by itself has no meaning; it is always directly followed by either R or U, but 'R' in this position should not be confused with an (R) signifying a V-belt drive for a compressor ("see below").
• Five foot (60-inch) cut; replaced flat belt with Texrope V-belt system.