Übersetzung für 'coolant circuit' von Englisch nach Deutsch

coolant circuit

Kühlmittelkreislauf {m} [System]

---

primary coolant circuit

Primärkühlmittelkreislauf {m}nucl.

---

Werbung

direct-current intermediate circuit <DC intermediate circuit>

Gleichspannungs­zwischenkreis {m}electr.

sample-and-hold circuit <S&H circuit>

Abtast-Halte-Glied {n} [S&H-Schaltung]electr.

resistor-capacitor circuit <RC circuit>

RC-Glied {n} [Widerstand-Kondensator-Kreis]electr.

normally open circuit <no-circuit>

Arbeitsstromschaltung {f}electr.

alternating current circuit <AC circuit>

Wechselstromkreis {m} <WS-Kreis>electr.

coolant

Kühlmedium {n}materialtech.

Kühlmittel {n}MedTech.tech.

kühlendes Mittel {n}

Kühlflüssigkeit {f}

Kühlwasser {n} [zur Motorkühlung]

coolant duct

Kühlkanal {m} [z. B. in Zylinderkopf]

coolant passage

Kühlkanal {m} [z. B. in Zylinderkopf]

coolant circulation

Kühlmittelumlauf {m}

coolant pump

Wasserpumpe {f} [für Motorkühlmittel]tech.

Kühlmittelpumpe {f}

Kühlflüssigkeitspumpe {f}

coolant return

Kühlmittelrücklauf {m}

reactor coolant

Reaktorkühlmittel {n}nucl.

coolant motor

Kühlmittelmotor {m}

coolant hose

Kühlmittelschlauch {m}tech.

• The core is composed of 27,000 fuel elements. The fuel elements use low enriched uranium with a design mean burn up of 80,000 MWd/t. The pressure of the primary helium coolant circuit is 3.0 Mpa.
• During a hydraulic test of the primary coolant circuit, the reactor became prompt critical and generated full effect for 10–15 seconds.
• Atypical of the contemporary racing cars, Lotus 23 models sometimes experienced an over-cooling problem when the thermostat was not installed in the coolant circuit in sprint races, and displayed a very stable water/oil temperature in endurance racing.
• Split-cooling is a feature that separates the coolant circuit for the prime mover and the circuit for the air pumps and turbocharger.
• In case of a coolant circuit failure with simultaneous loss of external power, the essential power can be supplied by the spinning down turbogenerators for about 45 to 50 seconds, during which time the diesel generators should start up.

• In some cases where excess liquid has been collected in a bottle, this may be 'sucked' back into the main coolant circuit.