Übersetzung für 'load amplitude' von Englisch nach Deutsch

load amplitude

Belastungs­amplitude {f}tech.

Lastamplitude {f}engin.tech.

---

Werbung

amplitude-amplitude distortion

Amplituden-Amplituden-Verzerrung {f}electr.

peak-to-peak amplitude <pk-pk amplitude>

Spitze-Spitze-Amplitude {f}electr.

alternating current load <AC load>

Wechselstrombelastung {f}electr.

amplitude

Amplitude {f}

Schwingungs­weite {f}

Weite {f}

Umfang {m}

oscillation amplitude

Schwingungs­amplitude {f}electr.

Oszillationsamplitude {f}med.phys.

amplitude-quantized {adj}

amplitudenquantisiertphys.

wobble amplitude

Wobbelamplitude {f}electr.

amplitude [pendulum]

Ausschlag {m} [Pendel]

velocity amplitude

Schnellamplitude {f}audio

Geschwindigkeitsamplitude {f}audio

large amplitude

große Amplitude {f}

pulse amplitude

Impulsamplitude {f}electr.phys.

power amplitude

Kraftamplitude {f}audio

vibration amplitude

Vibrationsamplitude {f}phys.

Schwingamplitude {f}phys.

amplitude response

Amplitudengang {m}electr.phys.

• The motion will continue at constant amplitude as long as the energy extracted from the forward motion, and manifesting itself as increased kinetic energy of the wheel set at zero yaw, is equal to the potential energy lost by the lowering of the axle load at maximum yaw.
• The power supply voltage directly amplitude-modulates the output voltage, dead time errors make the output impedance non-linear and the output filter has a strongly load-dependent frequency response.
• Thanks to the introduction of event density as an additional measurement dimension, a DPX Spectrum display can be used to discriminate between load-induced and jitter-induced movement of the waveform, adding an additional dimension to frequency and amplitude.
• The amplitude of the FGW increases sharply and, with a sufficient load, destruction begins.
• Only the amplitude of the load change is relevant, not the absolute value.

• The basic principle of dynamic voltage restoration is to inject a voltage of the magnitude and frequency necessary to restore the load side voltage to the desired amplitude and waveform, even when the source voltage is unbalanced or distorted.
• As the amplitude of the signal increases, the higher rectified voltage results in an inrush current towards the reservoir capacitor; the increased load results in an increased damping of the tuned circuit, resulting in nearly constant amplitude on the output despite the amplitude increase of the incoming signal.
• The filtering reduces the amplitude of AC mains frequency present in the rectifier output and can be as simple as a single capacitor or more complex such as a pi filter.
• Since the filter and wires in the circuit have resistance they consume energy and the amplitude of the signal drops as it passes through the filter.
• If the centre of gravity is behind the hinge, the surface can move like a pendulum and undergo forced simple harmonic motion with increasing amplitude.

• In a symmetric three-phase power supply system, three conductors each carry an alternating current of the same frequency and voltage amplitude relative to a common reference, but with a phase difference of one third of a cycle (i.e., 120 degrees out of phase) between each.
• If the amplitude of the wave and frequency of the waves corresponds to a factor similar to the distance between the hulls even relatively short waves can cause a dismasting.
• Force output undergoes much the same effects as EMG amplitude in response to resistance training.
• Consequently, the DC voltage level limits the amplitude of the generator phase voltage.
• An ideal impact to a structure is a perfect impulse, which has an infinitely small duration, causing a constant amplitude in the frequency domain; this would result in all modes of vibration being excited with equal energy.

• The simplest (and also, the highest-amplitude) waveform that can be produced by a two-level converter is a square wave; however this would produce unacceptable levels of harmonic distortion, so some form of pulse-width modulation (PWM) is always used to improve the harmonic distortion of the converter.