Übersetzung für 'signal amplitude' von Englisch nach Deutsch

signal amplitude

Signalamplitude {f}

---

amplitude modulated signal

amplitudenmoduliertes Signal {n}

---

Werbung

amplitude-amplitude distortion

Amplituden-Amplituden-Verzerrung {f}electr.

blanking and sync signal <BAS signal>

Austast- und Synchronisiersignal {n}electr.RadioTV

peak-to-peak amplitude <pk-pk amplitude>

Spitze-Spitze-Amplitude {f}electr.

video, blanking, and sync signal <VBS, VBS signal>

Bild-Austast-Synchron-Signal {n} <BAS, BAS-Signal>electr.RadioTV

amplitude

Weite {f}

Amplitude {f}

Umfang {m}

Schwingungs­weite {f}

amplitude permeability

Amplitudenpermeabilität {f}electr.

large amplitude

große Amplitude {f}

tidal amplitude

Tidenhub {m}

amplitude modulator

Amplitudenmodulator {m}electr.

amplitude object

Amplitudenobjekt {n}electr.optics

amplitude fluctuation

Amplitudenfluktuation {f}phys.

vibration amplitude

Schwingungs­amplitude {f}engin.phys.

Schwingweite {f}phys.

stimulus amplitude

Reizamplitude {f}med.

amplitude filter

Amplitudensieb {n}electr.

amplitude grating

Amplitudengitter {n}

wave amplitude

Wellenamplitude {f}phys.

• Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.
• In some applications, such as harmonic multiplication, a large signal amplitude alternating voltage is applied across a varicap to deliberately vary the capacitance at signal rate to generate higher harmonics, which are extracted through filtering.
• But when the reflected signal was out of phase then the combined radio signal amplitude would decrease, which would decrease the plate current.
• the difference between the frequency of the carrier and its center frequency, has a functional relation to the modulating signal amplitude.
• Single-ended signaling is less expensive to implement than differential, but it has a distinct disadvantage: a single-ended system requires a power supply voltage equal to the maximum amplitude of the signal to be received whereas a differential system only requires a voltage half of the signal amplitude to be received.

• In addition, Dolby Digital and DD+ contain additional metadata to permit error-free translation into range-restricted downstream channels, such as RF modulation, where excessive output signal amplitude may result in significant distortion or modulation errors.
• Many applications of the lock-in amplifier only require recovering the signal amplitude rather than relative phase to the reference signal.
• Software Defined Radios (SDRs) acquire and process signals differently, and determine S-readings by direct measurement of RF signal amplitude.
• In telecommunication, transmit-after-receive time delay is the time interval from removal of RF energy at the local receiver input until the local transmitter is automatically keyed on and the transmitted rf signal amplitude has increased to 90% of its steady-state value.
• For a transmitter, the attack-time delay is defined as the interval from the instant the transmitter is keyed-on to the instant the transmitted RF signal amplitude has increased to a specified level, usually 90% of its key-on steady-state value.

• Small-scale fading refers to the rapid changes in radio signal amplitude in a short period of time or distance of travel.
• calculation is proportional to the 4th power of the signal amplitude.
• Since the channel has minimal loss at DC, the maximum signal amplitude is largely unaffected.
• On a shared, electrical bus such as 10BASE5 or 10BASE2, collisions can be detected by comparing transmitted data with received data or by recognizing a higher than normal signal amplitude on the bus.
• Accounting for attenuation effects in ultrasound is important because a reduced signal amplitude can affect the quality of the image produced.

• Coherent detection is needed to capture the signal phase information in addition to the signal amplitude information.
• While satellites in Molniya orbits require considerably less launch energy than those in geostationary orbits (especially launching from high latitudes), their ground stations need steerable antennas to track the spacecraft, links must be switched between satellites in a constellation and range changes cause variations in signal amplitude.
• The capacitor in the circuit above stores charge on the rising edge and releases it slowly through the resistor when the input signal amplitude falls.
• As an aside, it may be noted that real-world departures from this linear two-pole model occur due to two major complications: first, real amplifiers have more than two poles, as well as zeros; and second, real amplifiers are nonlinear, so their step response changes with signal amplitude.