Übersetzung für 'contact washer' von Englisch nach Deutsch

contact washer

Kontaktscheibe {f}tech.

---

serrated contact washer

gezahnte Kontaktscheibe {f}tech.

---

Werbung

normally closed contact <NC contact, N/C contact>

Öffner {m}electr.

normally open contact <NO contact, N/O contact>

Schließer {m} [im Ruhezustand offener Melder]electr.

washer

Zwischenscheibe {f}tech.

Unterlegblech {n}tech.

Beilagscheibe {f}tech.

Wäscher {m}tech.

Mutterscheibe {f}tech.

U-Scheibe {f} [kurz für: Unterlegscheibe]tech.

Beilagescheibe {f}constr.tech.

Unterlagscheibe {f}tech.

Unterlegscheibe {f}tech.

Scheibe {f} [Dichtung]tech.

Unterlagsscheibe {f}tech.

seal washer

Dichtungs­ring {m}tech.

insulating washer

Isolierscheibe {f}electr.tech.

safety washer

Spannscheibe {f}tech.

compensating washer

Auswuchtscheibe {f}tech.

window washer

Fensterputzer {m}jobs

split washer

Federring {m}tech.

parts washer

Teilewaschgerät {n}tech.

• Also, some components that contact the milk such as the drain valve cannot be properly cleaned automatically without disassembling the valve and retaining washer and directly scrubbing in soapy water.
• They are installed just like any other washer, after which the sides of the tab are bent up to make contact with the sides of the head of the fastener.
• ... , "tsuba" in Japanese) w/ rubber retaining washer: the hilt or guard of the sword is intended to offer some protection to the hands, but is more commonly used as a point of contact in close-quarters contest.
• This creates contact between the washers and ball bearings inside of the gear/pulley.
• The ancient Egyptian noble Parennefer was Akhenaten's close advisor before he came to the throne, and in later times served as his Royal Butler, an office which brought him into intimate contact with the king.

• This type works well because the surface is rounded so that a small surface area is in contact, but it does not have extremely high stress at one point like that of a cone point.
• The gasket is used to maintain the sample's contact with the culets, where the pressure is at a maximum.
• Such designs often place the hinged disk on an inner cable or rod that is manipulated by a trigger at the other end; by pulling the trigger, the disk is forced to rotate into contact with the barrel surface.