Übersetzung für 'outside diameter' von Englisch nach Deutsch

outside diameter

Außendurchmesser {m}

---

tyre outside diameter [Br.]

Reifenaußendurchmesser {m}automot.

---

Werbung

diameter

Diameter {m}

Dicke {f}

workpiece diameter

Werkstückdurchmesser {m}tech.

head diameter

Kopfdurchmesser {m}med.tech.

diameter range

Durchmesserbereich {m}

shank diameter

Schaftdurchmesser {m}tech.

shaft diameter

Schaftdurchmesser {m}tech.

Wellendurchmesser {m}

polar diameter

Poldurchmesser {m}

Polardurchmesser {m}

tool diameter

Werkzeugdurchmesser {m}tech.

pupil diameter

Pupillendurchmesser {m}med.

pipe diameter

Rohrdurchmesser {m}constr.tech.

inside diameter

lichter Durchmesser {m}tech.

cable diameter

Kabeldurchmesser {m}electr.

clamping diameter

Spannkreisdurchmesser {m} [selten]tech.

wire diameter

Drahtdurchmesser {m}tech.

bar diameter

Stabdurchmesser {m}tech.

drilling diameter

Bohrdurchmesser {m}constr.tech.

exit diameter

Austrittsdurchmesser {m}tech.

• Widths of tires and corresponding ISO width designations may vary, though the wheel outside diameter remains approximately the same.
• The tubes come in a variety of lengths and a standard outside diameter of 48.3 mm.
• bead seat diameter (the term, bead seat diameter (BSD), is used in the ETRTO tire and rim sizing system), and the average 29" mountain bike tire is (in ISO notation) 59-622 corresponds to an outside diameter of about 29.15 inches (740 mm).
• Most Category 5 cables can be bent at any radius exceeding approximately four times the outside diameter of the cable.
• Diaphragm couplings transmit torque from the outside diameter of a flexible plate to the inside diameter, across the spool or spacer piece, and then from inside to outside diameter.

• The fins of the Mk 40 flipped forward from the rear when the rocket left the launching tube, but in the Hydra they are curved to match the outside diameter of the rocket fuselage and flip sideways to open, which is referred to as WAFAR (Wrap-Around Fin Aerial Rocket) instead of FFAR (folding-fin aerial rocket).
• Typically, a slip ring consists of a stationary graphite or metal contact (brush) which rubs on the outside diameter of a rotating metal ring.
• Since the rollers are thin, the outside diameter of the bearing is only slightly larger than the hole in the middle.
• Also new, (for 1978 only), were slightly revised standard Luxury wheel covers, with fewer ribs along the outside diameter of a slightly more-convex/bulging brushed center portion of the wheel cover.
• In PTP mode, used for DVD-ROM, both layers start recording at the inside diameter (ID) with the lead-in and end at the outside diameter (OD) with the lead-out.

• Fabrication of most cans results in at least one "rim"—a narrow ring slightly larger than the outside diameter of the rest of the can.
• Flange gaskets come in a variety of sizes and are categorized by their inside diameter and their outside diameter.
• Capillaries have no smooth muscle surrounding them and have a diameter less than that of red blood cells; a red blood cell is typically 7 micrometers outside diameter, capillaries typically 5 micrometers inside diameter.
• AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in [...] -inch increments.
• "Pot broaches" are cut the inverse of an internal broach; they cut the outside diameter of a cylindrical workpiece.

• A spindle sabot uses a set of at least two and upwards of four matched longitudinal rings or "petals" which have a center section in contact with a long arrow-type projectile; a front section or "bore-rider" which centers that projectile in the barrel and provides an air scoop to assist in sabot separation upon muzzle exit, and a rear section which both centers the projectile, provides a structural "bulkhead", and seals propellant gases with an obturator ring around the outside diameter.
• A typical 48 channel multicore has an outside diameter of [...].
• Under Holland's plan, each of the two tubes would have an outside diameter of [...] including exterior linings, and the tubes would contain two-lane roadways with a total width of [...].
• The structure would have an outside diameter of [...] with a [...] ring interior cross-section diameter and would provide 0.08 to [...] partial gravity.
• in outside diameter (OD) and [...] in length. Two pin sizes are common in the jacks for this size plug body, [...] and [...] , and the plugs should match.