Übersetzung für 'pipework' von Englisch nach Deutsch

pipework

Verrohrung {f}

Rohrleitung {f}

pipework {sg}

Rohrleitungen {pl}constr.tech.

---

copper pipework {sg}

Kupferrohrleitungen {pl}tech.

pipework components

Rohrleitungs­teile {pl}

pipework system [relatively rare]

Rohrleitungs­system {n}tech.

• Mineral wools are used on all types of pipework, particularly industrial pipework operating at higher temperatures.
• These differences mean that most of the connections and pipework are not remotely interchangeable between Hornet Specials and F-types.
• In the photograph of an industrial filtration unit (right), it is possible to see that the recycle pipework is considerably larger than either the feed pipework (vertical pipe on the right hand side) or the permeate pipework (small manifolds near to the rows of white clamps).
• From mid-2014 until late-2016 improvement works took place throughout the majority of the school to replace an ageing pipework and central heating system.
• High-pressure copper pipework can suffer from work hardening in use and become dangerously brittle: it may be necessary to treat these by annealing before refitting.

• Continuous flow EDS pass liquid effluent through a distance of heated pipework to sterilise it.
• Panels of drywall are fastened either directly to the ceiling joists or to a few layers of moisture-proof plywood which are then attached to the joists. Pipework or ducts can be run in the gap above the ceiling, and insulation and fireproofing material can be placed here.
• It is possible that the sprinkler system is a rare surviving example, with cast iron pipework and 1929 sprinkler heads still intact.
• Where this system is used, all the metal pipework must be bonded i.e.
• Buzzard was temporarily shutdown twice in late 2019 for repairs to topside pipework.

• Any water flushing methods (such as uni-directional flushing, air/water flushing or closed loop with sidestream filtration) are limited by the fact that as water flows through pipework, a boundary layer of slower flow occurs at the pipe surface, so the wall shear generated is small, even at flushing velocities of several metres per second.
• A typical run-around coil system comprises two or more multi-row finned tube coils connected to each other by a pumped pipework circuit.
• Magnetic filters are fitted on the boiler's pipework to collect magnetite from the circulating water before it has a chance to build up and lower the efficiency of the heating system.
• A rebuilding, again recycling much of Dallam's original pipework, was done in 1856 by London organ builders Gray & Davison, then at the height of their fame.