Übersetzung für 'plug bolt' von Englisch nach Deutsch

plug bolt

Steckbolzen {m}constr.

---

plug-in bolt

Steckbolzen {m}constr.

• When the cocking piece ending in a cocking ring is pulled rearward and turned horizontal, the cocking piece sear can be placed in a recessed safety slot in the bolt plug.
• All early twin cam engines appear to have the 14 bolt rocker cover (6 for the cover and 8 for the bolt-in plug holders).
• Busbars carry the current from incoming line ("hot") conductors to the breakers, which are secured to the bus with either a "bolt-on" connection (using a threaded screw) or a "plug-in" connection using a retaining clip.
• The plug has a straight-shaped slot known as the "keyway" at one end to allow the key to enter the plug; the other end may have a "cam" or lever, which activates a mechanism to retract a locking bolt.
• They can be used to join multiple conductors, to connect wires to a printed circuit board, or to terminate a cable into a plug or socket.

  ---

• Other varieties of wall plug are mechanical anchors for heavy duty loads and hollow wall fixings for fixing to plasterboard.
• Some mortars use a fixed firing pin mounted in the breech plug.
• Within the framework of GM's vehicle electrification strategy, and following the US market introduction of the Chevrolet Volt plug-in hybrid vehicle in late 2010, the Chevrolet Spark EV was released in June 2013 as the first all-electric passenger car marketed by General Motors in the U.S.
• The drivetrain was covered by the rear bodywork, which could be removed as a unit by loosening one bolt and unplugging the lead to the taillight.
• For safety reasons, the JROTC M1903s are made permanently unable to fire by plugging the barrel with a steel rod, or having it filled with lead, soldering the bolt and welding the magazine cutoff switch in the "on" position.

  ---

• The connector has 12 pins for electrical connections (both power and data), 2 double-sided "hooks" on the plug and matching holes in the phones connector for keeping the plug safely in place.
• For shooting historic Gewehr 43's commercial "shooters kits" have been developed that basically replace the gas cup and the gas plug with new ones, and the gas plug is threaded to accept different sized gas orifices so the gas system can be adjusted to cycle reliably with the specific pressure behavior of the ammunition used.
• The ignition coil fired both cylinders simultaneously (wasting one spark) and the spark plug wear was significantly greater than it should have been; 6000 miles was not uncommon for a spark plug.