Übersetzung für 'stiffeners' von Englisch nach Deutsch

stiffeners

Versteifungen {pl}

stiffeners [in back of shoes]

Hinterkappen {pl}cloth.

• T-section shaped stiffeners can be seen running vertically down the sides of the girders at the bearing ends.
• The plate is supported against those loads at its edges by stiffeners and beams.
• Vertical stiffeners prevent the web plate from buckling under shear stresses.
• In 2019 they infused the hull and stiffeners of a 43m composite yacht in a single shot using vacuum infusion technology and proprietary 3D resin flow.
• Sheets under diagonal tension are supported by stiffeners that as a result of sheet buckling carry a distributed load along their length, and may in turn result in these structural members failing under buckling.

• A punt chassis is similar to the platform chassis, but in addition to the lower platform there are also deep raised sides. These give vertical stiffness, without requiring added stiffeners.
• The walls were made of horizontal timbers, in the main hall they were reinforced by stiffeners.
• The recycled aluminum alloys can be used in aircraft parts such as stiffeners and flaps, where a growth in fatigue stress and fracture toughness are not critical to the component’s integrity.
• The steel subcontractor stated they did not provide web stiffeners to the beam as they weren't indicated on the engineering drawings.
• Ariel has a "long-standing relationship with Honda", This gives the frame's diagonal stiffeners their distinctive triangular vee section, rather than the usual round-section tube.

• Waist cinchers and waspies from the 1980s are a type of wide, laced belts with elastic fabric and soft plastic stiffeners.
• Round ducts require typical stiffeners at roughly 3 diameter spacing, or roughly 20 ft.
• Steel industry practice assigns structural shapes representative designations for convenient shorthand description on drawings and documentation: Channel sections, with or without flange stiffeners, are usually referenced as C shapes; Channel sections without flange stiffeners are also referenced as U shapes; Point symmetric sections that are shaped similar to the letter Z are referenced as Z shapes.