Übersetzung für 'unity gain' von Englisch nach Deutsch

unity gain

Verstärkungs­faktor {m} eins / Eins

---

unity gain frequency

Transitfrequenz {f}

---

Werbung

unity

Einheitlichkeit {f}

Geschlossenheit {f}

Gesamtheit {f}

Eintracht {f}

Eins {f}

Einigkeit {f}

Einheit {f} [Gesamtheit, Ganzheit, Einigkeit, Einheitlichkeit]

unity principle

Einheitsprinzip {n}

unity party

Einheitspartei {f}pol.

universal unity

All-Einheit {f}philos.

unity [element]

Einselement {n} [auch: Eins-Element]math.

imperial unity

Reichseinheit {f}hist.

church unity

Kircheneinheit {f}relig.

Einheit {f} der Kircherelig.

Einheit {f} der Kirchenrelig.

national unity

Volkseinheit {f}pol.

unity government

Einheitsregierung {f}pol.

religious unity

Glaubenseinheit {f}relig.

legal unity

Rechtseinheit {f}law

unity candle

Traukerze {f}relig.

• An emitter follower is a type of non-inverting amplifier, indicating that the signal at the emitter of a transistor is following (that is, matching with unity gain but perhaps an offset) the input signal.
• For active crossovers inversion is usually done using a unity gain inverting op-amp.
• Mackay and Webb played several gigs around London with Tony Irving in a free noise / jazz band called Unity Gain, releasing a lathe cut LP in January 2014 titled "Sounds from the Room".
• Due to the statistics of photon shot noise, the desirable properties of signal-to-noise ratio (SNR) and sensor unity gain both scale with the square root of pixel area.
• "When Broken Is Easily Fixed" was recorded at Mount Fairview and Unity Gain between January and February 2003 with producer Justin Koop.

• A gain of factor 1 (equivalent to 0 dB) where both input and output are at the same voltage level and impedance is also known as "unity gain".
• The generic unity-gain Sallen–Key filter topology implemented with a unity-gain operational amplifier is shown in Figure 1.
• The "amplifier" is actually an electrometer, sometimes referred to as a "unity gain amplifier"; its main purpose is to reduce the electrical load on the small signals (in the mV range) produced by cells so that they can be accurately recorded by low-impedance electronics.
• For devices such as operational amplifiers that are designed to have a simple one-pole frequency response, the gain–bandwidth product is nearly independent of the gain at which it is measured; in such devices the gain–bandwidth product will also be equal to the unity-gain bandwidth of the amplifier (the bandwidth within which the amplifier gain is at least 1).
• If the voltage is transferred unchanged (the voltage gain "Av" is 1), the amplifier is a unity gain buffer; also known as a voltage follower because the output voltage "follows" or tracks the input voltage.